Features:
84 X 84 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND. Support different types of MCU, such as the SPI, MCS51 serial mode 0 of AVR. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board, without connecting cable. The metal hooks on the module can fix the module on the printed board, which is very easy to install and replace.
LCD controller/driver chip has been bound to LCD chip, the volume of LCD is small
Low power consumption, the working current in normal situation is lower than 200μA, and has power-down mode.
LCD5110 Module:
Pins:
1.RST---------- reset
2.CE------------chip selection
3.DC------------data/commands choice
4.DIN-----------serial data line
5.CLK-----------serial Clock Speed
6.3.3V----------VCC
7.LIGHT---------backlight control terminal
8.GND-----------power negative
Note:
84 X 84 dot matrix LCD,can show 4 lines of characters
Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND. Support different types of MCU, such as the SPI, MCS51 serial mode 0 of AVR. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board, without connecting cable. The metal hooks on the module can fix the module on the printed board, which is very easy to install and replace.
LCD controller/driver chip has been bound to LCD chip, the volume of LCD is small
Low power consumption, the working current in normal situation is lower than 200μA, and has power-down mode.
LCD5110 Module:
- Power supply voltage:2.7V-3.3V
- Backlight power supply voltage: highest 3.3V
- Module size: 43.6mm x 43.1mm
- Backlight: Blue
Pins:
1.RST---------- reset
2.CE------------chip selection
3.DC------------data/commands choice
4.DIN-----------serial data line
5.CLK-----------serial Clock Speed
6.3.3V----------VCC
7.LIGHT---------backlight control terminal
8.GND-----------power negative
Note:
- "LIGHT" linked with GND, backlight to be lit.
- Use a 3.3V controller, otherwise the display could be quite vague.
84x48 Nokia LCD Arduino Modulis
- Gamintojas: Generic
- Prekės kodas: 84x48 Nokia LCD Module for Arduino
- Ar turime: Sandėlyje
- €6,00
-
€4,53
- Be mokesčių: €3,74